[Homeroast] Quest M3

Steve Sakoman sakoman at gmail.com
Sat Oct 23 13:32:21 CDT 2010


On Sat, Oct 23, 2010 at 9:41 AM, ricky carter <rickylc99 at gmail.com> wrote:
> Is there a place to mount the ET probe already provided or does the face
> plate need to be drilled?

There's a drilled & tapped hole on the right side of the face plate,
at about the same level as the tryer.  As shipped, there is a bolt
screwed hand tight into this spot.

But from what I read online, this location isn't a particularly good
one for useful measurements.

There's a pretty extensive discussion of thermometer mounting points here:

http://www.home-barista.com/home-roasting/another-airhead-drums-initial-impressions-of-quest-m3-t12502.html

Steve



More information about the Homeroast mailing list